The EPUS-Nano is an easy-to-use, compact device featuring a potent mini compressor that emits a fine, atomized mist of cold liquid from water or liquid-based ingredients such as ampoules, toners, or Vitamin C. This refreshing mist helps to tighten pores, boost skin elasticity, and is rapidly absorbed, enhancing your skin's appearance. Another benefit of using the EPUS-Nano is that it allows you to save on your investment in compatible skincare products, as you don't need to touch or directly apply them to your face.
To operate the device, simply press the power button, and you can adjust the intensity of the mist by pressing the button multiple times. Angle the Nano about 15 degrees downwards while the vial is facing up while applying the Nano sprayer to your face. To switch off the device, press and hold the power button for few seconds. Please note that the Nano is not waterproof, so ensure it does not come into contact with liquids. To maintain the device's optimal performance, clean it after each use by combining equal parts rubbing alcohol (70%) and water in a vial (25-50% fill), then activating the sprayer to use up the entire cleaning solution.
To use the EPUS-NANO, follow these easy steps:
1. Attached the vial, included with the NANO, to the rubber portion of the EPUS-Nano body. Press and hold the power button for a few seconds to turn the device on. You will notice the ampoule is spraying out in few seconds.
2. Press the power button quickly again to increse the next power level to increase the intenstiy of the mist. You can choose from two levels of power according to your preference.
3. Hold the device about 10 inches away from your face, while the viale is facing upward and in 15 degrees angle, and spray the ampoule on your face. The atomized mist is quickly absorbed into the skin, tightening pores and increasing elasticity.
4. Press and hold the power button for a few seconds to turn the device off when you're done. It's that simple!
5. To optimally maintain the device, mix 1 part 70% rubbing alcohol and 1 part distilled water in the vial (fill approximately 25 - 50%) and attach to the Nano. Spray the enitre mixture out after you are done using it to ensure that your Nano continues to perform at its best.
Tab 3 content
Need a new paragraph? Try using Shift + Enter